Lower the vehicle, then open the hood, insofar as is feasible and safe.
Remove the cover under ABS fuse holder / relay box.
Remove air hose
, Resonance and air cleaner assembly.
Relieve pressure on fuel, as described in the information security technician.
Remove the fuel feed pressure hose and charcoal canister hose from the intake manifold.
Remove the accelerator cable of a loosening locknut and then slide the end of the accelerator cable.
Disconnect the motor electrical connector on the left side of the engine.
Remove the fuel hose and brake booster vacuum hose return.
Disconnect the motor electrical connectors and terminals using the right side of the engine.

Remove the battery cables and start the action under the cover holder fuse / relay box, and then remove the ABS electrical wire terminal of the battery.
Disconnect the engine ground cable on the cylinder head, then remove the power steering belt and pump. Do not remove the power steering hoses.
Remove A / C compressor and belt. Do not remove the A / C pipe.
Remove transaxle ground cable and ATF cooler lines on automatic transaxles.
Remove the radiator and hoses for heating the engine.
Raise and support vehicle, then remove the exhaust pipe and housing.
On models with automatic transaxle, disconnect the cable to the transaxle shift control.
On models with manual transaxle, remove the clutch slave cylinder, and then disconnect the hose / tube assembly. No pipe coupling assembly.
Remove the switch rod and extension rod.

Remove the damper fork and then cancel the suspension lower arm ball joint.
Remove driveshafts, then lower the vehicle. Tie on plastic bags had just run for protection.
Attach lifting equipment suitable engine, then increase the engine a little to lighten the load on the engine mounts.
Remove the front engine mounts and the media so that the rear engine hanger.
Do the following:
Remove cruise control actuator.
Remove the screw and nut support, and then mount bolt.
Remove the side engine mount.
Remove the transaxle mount nuts, then loosen the mounting screw and pivot side of the transaxle pan.

Ensure that the engine is free of tubes and electrical connections, then remove from the vehicle engine.
Engine Mount Tightening Sequence

Reverse procedure to install, says the following:

When you install the driveshafts, the spring clip and makes driveshafts, click groove of difference.
To recharge the cooling system, bleed the cooling system air bleed screw on the heater valve is open.
Adjust all control cables as needed.
On models equipped with a radio-coded theft protection system based on the Skoda vehicle communication system arming and disarming devices procedures. On models equipped with an airbag system, refer to the Information System Security Technical arming and disarming procedures.